Warranty - zappi -2H07UW-G User Manual

PEN Fault!
Fault code 29
Overload !
Fault code 30
Bad Voltage Range !
Over Voltage!
Under Voltage!
Fault code 31
Overheating!
Voltage Mismatch !
Fault code 32
Charge Blocked !
If any of the above faults persist then stop using zappi and contact your supplier or myenergi Technical
Support.

23. Warranty

Full details of the myenergi product warranty are available on our web site or by using this QR code.
The internal protection against
the loss of the PEN conductor on
the electricity supply has tripped.
The EV is drawing too much
current – the output is switched
off.
zappi has detected that the
supply voltage is too high/low and
has disconnected the EV to
protect it.
The zappi unit is too hot – the
output is switched off.
The output voltage detected by
zappi and the built-in protection
components is not the same.
zappi has detected that the EV
has repeatedly tried to start a
charge even though the EV has
previously reached
Complete" i.e. The battery is full,
the battery has reached a charge
level set in the EV, or the charge
has been stopped by a timer in the
EV.
Unplug the EV, make sure that the
fault has been removed then press
and hold the
unit.
Unplug the EV, press and hold the
button to reset the unit.
Unplug the EV, make sure that the
fault has been removed and hold
the button to reset the unit.
Make sure that the zappi is
properly ventilated (e.g. has not
been covered).
Charge will resume once the unit
has cooled down again.
Unplug the EV, press and hold the
button to reset the unit
Unplug the EV
Charging will continue when the
EV is plugged in again
"Charge
button to reset the
Page 31 of 41