Table of Contents
Advertisement
Chapter
4
Initial Setup
4
Turning the TV On for the First Time
• This instruction manual explains the basic instructions for operating this unit. All pictures shown are for illustrative
purpose only. Actual product may vary due to product enhancement. Unless otherwise stated, all operations described
are based on remote control use.
• Some DVDs are produced in a manner that allows for specific or limited operation during playback. Therefore, this unit
may not respond to all operating commands. This is not a defect.
• When an item in main menu is displayed gray, it means that the item is not available or cannot be adjusted.
• If you are going to watch TV using a set-top box, simply connect your TV and set-top box via a HDMI cable and select
HDMI in the Input Source menu.
1. Connect one end of the RF coaxial cable to the
aerial socket on the wall and the other end of
the cable to the RF (75Ω) socket at the rear right
bottom of your TV.
Do not connect the TV to the mains
supply until you have completed all the
connections.
2. Unwind the mains cable to its full length. Connect
the mains cable to the mains socket after you have
completed all the connections.
3. At this stage, the TV switches to standby mode. The
red LED indicator will illuminate on the front panel of
the TV.
4. In standby mode, press the
panel of the TV or on the remote control to turn the
TV on. The red LED indicator will turn blue.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the rear panel of the TV or on the remote control is only used for switching the TV into standby, it does
not disconnect the TV from the mains power. To completely disconnect the mains power, please remove the mains plug
from the mains socket.
First Time Installation
1. The first time you turn the TV on, it will go straight into the First Time Installation menu.
Please ensure the aerial is plugged in. (If you have already installed the TV using the Quick
Start Guide, please go to the section "Selecting the Input Source" on the next page.)
If you are going to watch TV using a set-top box, press the EXIT
button on the remote control then skip this section. Then press the
INPUT button on the remote control to select HDMI mode.
button on the rear
OR
RF coaxial cable
(not included)
Digital Audio Output
HDMI3
RF
(Optical)
To the mains
socket
COMMON INTERFACE (CI)
USB
AV
YPbPr
First Time Installation
WELCOME:
We hope you will be very
happy with your new TV
Please ensure aerial is plugged
in!
Then press [OK] button.
OK
Select
EXIT
Exit
21
Advertisement
Table of Contents
