Troubleshooting - Gigaset E450 Manual

Gigaset E450 / USA EN / A31008-M17xx-B101-1-19 / appendix.fm / 28.3.06
Appendix

Troubleshooting

The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
2. The battery pack is empty.
¥
Charge/replace the battery pack
(page 10).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press and hold the pound key
(page 13).
"Base station x" is flashing in the display.
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
2. The handset has been de-registered.
¥
Register the handset (page 21).
3. The base station is not switched on.
¥
Check the base station mains adapter
(page 7).
Base Search is flashing in the display.
The handset is set for
tion is switched on or within range.
¥
Reduce the distance between handset/base
station.
¥
Check the base station mains adapter
(page 7).
Handset does not ring.
The ringtone is switched off.
¥
Activate the ringtone (page 28).
You cannot hear a ringtone/dialing tone.
Base station's phone cord has been replaced.
¥
When purchasing a new cord, ensure that it
has the correct pin connections (page 8).
34
a
.
#
Best Base and no base sta-
The other party cannot hear you.
u
You have pressed the
set is "muted".
¥
Switch on the microphone again (page 13).
The incoming call number is not displayed
although CIP is set.
Caller ID is not enabled.
¥
Caller should ask network provider to acti-
vate Caller ID (CI).
You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the operating
instructions if necessary.
You cannot listen to messages on the net-
work mailbox.
Your phone system is set for pulse dialing.
¥
Set your phone system to tone dialing.
(INT) key. The hand-