Table of Contents
Advertisement
Appendix
Customer service & assistance
Problem
Nothing on the
display.
No wireless
connection to the
base, Base flashes
on the display.
You cannot hear a
ring or dial tone
from the fixed line
network.
If you have any further questions, your phone retailer will be happy to assist.
Authorisation
This device is intended for analogue phone lines in your network.
Country-specific requirements have been taken into consideration.
Hereby, Gigaset Communications GmbH declares that the radio equipment type Gigaset A116
is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
www.gigaset.com/docs.
This declaration could also be available in the "International Declarations of Conformity" or
"European Declarations of Conformity" files.
Therefore please check all of these files.
Environment
Environmental management system
Gigaset Communications GmbH is certified pursuant to the international standards
ISO 14001 and ISO 9001.
ISO 14001 (Environment): Certified since September 2007 by TÜV SÜD Management
Service GmbH.
ISO 9001 (Quality): Certified since 17/02/1994 by TÜV SÜD Management Service GmbH.
Cause
The handset is not switched on. Press the End call key
The batteries are empty.
The handset is outside the
range of the base.
The base is not switched on.
The phone cable supplied has
not been used or it has been
replaced by a new cable with
the wrong pin connections.
Solution
about 5 seconds or place the handset
into the base.
Charge or replace the batteries.
Move the handset closer to the base.
Check the mains plug on the base
p. 6.
Please always use the telephone cable
supplied or ensure that the pin
connections are correct when
purchasing from a retailer.: 3-4
assignment of phone wires /
EURO CTR37.
Appendix
for
15
Hide quick links:
Advertisement
Table of Contents
