Using Mount Kits; Grounding The Access Point; Connecting The Ethernet Cable - Aruba 580EX Series Installation Manual

Using Mount Kits

The 580EX Series access point can be installed on a wall or attached to a pole by using mount kits:
Table 3
Part Number
R9H97A
JW054A
JW055A
R6W11A
The 580EX Series access point does not ship with any mount kits. These mount kits are available as accessories
and must be ordered separately.
For installation instructions on mount kits, please refer to their respective installation guides found on the
Aruba support site https://asp.arubanetworks.com.
!
This 580EX Series access point is intended for installation in a RESTRICTED ACCESS LOCATION attached to a
pole or installed on a wall. Installers should disconnect power before working with or near the access point.
!
To prevent dropping and damage to the 580EX Series access point or to appendages of the handlers, extra
care should be taken when handling the access point.

Grounding the Access Point

Grounding the access point must be completed before powering up the device. The ground wire should be #8
AWG.
1. Strip the insulating jacket off of one end of the ground wire and place the bare conductor into the ground lug
(included in the package), then crimp the connection by pressing firmly with the crimping pliers.
2. Fasten the ground lug to the grounding point on the access point with the screw included in the package.

Connecting the Ethernet Cable

To connect the Ethernet cable to the access point, perform the following steps using the cable glands that ship
with your access point.
!
Failure to use the included cable glands can lead to connectivity and PoE issues.
The cable is not included and must be purchased separately. Purchase a suitable UV-resistant, outdoor rated,
CAT 5E or better shielded cable for use with the access point.
Aruba 580EX Series Hazardous Location Outdoor Access Points
Applicable Mount Kits for 580EX Series Access Point
Description
AP-OUT-MNT-V1A Aruba Outdoor AP Pole/
Wall Long Mount Kit.
AP-270-MNT-H1 Aruba Outdoor AP
Hanging or Tilt Install Mount Kit.
AP-270-MNT-H2 Aruba Outdoor AP Access
Flush Wall or Ceiling Mount.
AP-270-MNT-H3 Aruba Outdoor AP
Hanging or Dual-Tilt Install Mount Kit.
| Installation Guide
Supported Model
AP-585EX: Wall or Pole
AP-587EX: Wall or Pole
AP-585EX: Flat or Sloped Ceiling
AP-587EX: Wall
AP-585EX: Flat Ceiling
AP-587EX: Wall or Pole
AP-585EX: Flat or Sloped Ceiling
7