Burner Removal And Cleaning; Orifice Cleaning - Capital PRECISION Outdoor ACG40RBI.1N/L Use And Care Manual

Table of Contents

GRILL BURNER:

WARNING! To prevent burns, make sure the

burner is cool before removing for cleaning.

Remove the grill grates. Then lift out the radiant

trays. Grasp the burner and pull it up carefully

and slightly towards the rear wall of the unit so

the burner head comes off the brass orifice at

the front. Angle the burner sideways and remove.

(Fig. 14 and Fig. 15)

GRILL BURNER CLEANING:

Clean the burner exterior with a wire brush. Clear

stubborn scale with a metal scraper. Clear any

clogged ports with a straightened paper clip. Never

use a wooden toothpick as it may break off and

clog the port. Shake out any debris through the air

shutter. Use a flashlight to inspect the burner inlet to

ensure it is not blocked. If obstructions is seen, use a

straightened metal wire coat hanger to remove debris.

With the burner removed, remove the orifice and shine a flashlight through the opening to ensure there is no

blockage. Use a needle to clear any debris.

Be extremely careful not to enlarge the hole or break off the needle.

WARNING! It is extremely important to engage the burner on the orifice properly to prevent a fire

hazard or explosion.

Be careful not to upset the air shutter's original position (unless re-adjusting). Lower the rear of the burner into

the cut outs on the support channel at the rear of the burner box. Make sure it is level and does not rock. Light

all the burners and check for proper flame characteristics. If adjustments are necessary, refer to section on

flame adjustment in this guide. Do this prior to cooking on the grill.

BURNER REMOVAL AND CLEANING

Fig. 14

Fig. 15

Table of Contents