Accessories (Optional); Ec Declaration Of Conformity - STEINEL IR 180 COM2 Information

DIP switch factory settings
DIP 1 – DIP 5 = OFF
DIP 1 – Normal/test mode (NORM/TEST) (Fig� 5�4)
Test mode has priority over all other settings on the sensor switch and is used
for verifying proper working order as well for testing the detection zone. Irre-
spective of the ambient light level, the sensor switch activates the light to stay
ON for approx. 5 s in response to movement in the room (blue LED flashes on
detecting movement). All user-selected potentiometer settings apply in normal
mode (control dials). The sensor switch can also be set by means of the blue
LED without any load connected.
The DIP-switch test mode does not end automatically.
DIP 2 – Semi-automatic mode (MAN) / fully automatic mode (AUTO)
(Fig� 5�4)
Semi-automatic mode: (MAN)
The light only switches OFF automatically. Light is switched ON manually,
request light via the switch. It remains ON for the stay-ON time selected.
Fully automatic mode: (AUTO)
Depending on brightness, the light switches on automatically if movement is
detected and switches off when the brightness increases or upon expiry of the
stay-ON time. The light can be switched ON and OFF manually at any time.
This temporarily interrupts the automatic switching function.
DIP 3 button/switch (Fig� 5�4)
Selecting the "used" setting activates the integrated switch (A) as well as any
switch optionally connected to the S input. Set to "not used", the integrated
switch (A) and any switch optionally connected to the S input is deactivated
and therefore has no function.
The switch also influences interconnection with the P conductor.
(➜ "4� Installation")
DIP 4 switch ON/ON-OFF (Fig� 5�4)
In the ON-OFF setting, the light can be switched ON and OFF manually at any
time (except in pulse mode: no manual OFF). In the ON setting, light can no
longer be switched OFF manually. The stay-ON time starts from the beginning
again each time the switch is pressed.
Switch for light function
The switch function depends on sensor configuration as well as the current
operating situation.
➜ "Light function" table p� 31
- 28 -
7� Accessories (optional)
User remote control RC 5 EAN 4007841 592806
Additional functions, RC 5
– Light ON/OFF 4 h
– User reset
– 100 h burn-in
– Presentation mode
Service remote control RC 8 EAN 4007841 559410
Additional functions, RC 8
– Reach adjustment
– Time setting CH 1/CH 2
– ON delay / room surveillance, CH 2
– Test / normal mode
– Twilight setting
– Night-time operation
– Daylight operation
– Teach-IN
– Automatic / manual mode
– Reset
– IQ mode
Smart Remote EAN 4007841 009151
– Control via smartphone or tablet
– Replaces all remote controls
– Download the appropriate app and connect via Bluetooth
8� EC Declaration of Conformity
This product complies with the requirements defined in the following directives:
– EMC Directive 2014/30/EU
– RoHS Directive 2011/65/EU
– WEEE Directive 2012/19/EU
– Low Voltage Directive 2014/35/EU
– RED Directive 2014/53/EU
- 29 -