Steps
1. Insert the intrusion switch into its slot and slide the switch to secure it into the slot.
2. Connect the intrusion switch cable to the connector on the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
SD-card reader
Removing the SD-card reader
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
2.5-inch
5. Remove the
3.5-inch
6. Remove the
hard-drive and optical-drive
after working inside your
before working inside your
hard-drive.
hard-drive.
cage.
computer.
computer.
Removing and installing components
69