Steps
1. Remove the liner behind the VR heat sink module.
2. Align and adhere the VR heat sinks on the system board.
3. Tighten the four captive screws that secure the VR heat sinks to the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Power button
Removing the power button
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
2.5-inch
5. Remove the
3.5-inch
6. Remove the
hard-drive and optical-drive
About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
after working inside your
before working inside your
hard-drive.
hard-drive.
cage.
computer.
computer.
Removing and installing components
65