Datcon DT4227 UI Operating Instructions Manual page 12

Wiring plan, connecting
the 24 V type instrument
to the the low voltage
power supply
In case of DC supply the
polarity is indifferent.
12
The following figure shows the wiring plan, connecting the DT4227 UI
instrument to the low voltage power supply:
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to the wiring
plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
DT4227 UI (PS)
20200205-V0