Table of Contents
Advertisement
6. APPENDIX 1 INTERFACE
6. APPENDIX 1 INTERFACE
NOTE:
To prevent radiation and reception of electrical noise, the interface cables must meet the following requirements:
• In case of a parallel interface cable or serial interface cable, fully shielded and fitted with metal or metallised
connector housings.
• Keep as short as possible.
• Should not be bundled tightly with power cords.
• Should not be tied to power line conduits.
• A parallel interface cable to be used should conform to IEEE1284.
USB interface (Standard)
Standard:
Transfer type:
Transfer rate:
Class:
Control mode:
Number of ports: 1
Power source:
Connector:
LAN (Standard)
Standard:
Number of ports:
Connector:
LED status:
Link LED (Green)
Activity LED (Orange)
LAN cable:
Cable length: Segment length Max. 100 m
Conforming to V2.0 High speed
Control transfer, Bulk transfer
480M bps
Printer class
Status with the receive buffer free space information
Self power
Type A and Type B
Pin No.
Signal
1
VCC
2
D-
3
D+
4
GND
IEEE802.3 10BASE-T/100BASE-TX
1
RJ-45
Link LED
Activity LED
Activity
10BASE-T: UTP category 3 or category 5
100BASE-TX: UTP category 5
LED
LED Status
Link
ON
10Mbps link or 100Mbps link is detected.
OFF
No link is detected.
* Communication cannot be made while
the Link LED is off.
ON
Communicating
OFF
Idle
E6-1
ENGLISH VERSION
6. APPENDIX 1 INTERFACE
LAN status
Advertisement
Table of Contents
