Table of Contents
Advertisement
725
Users Manual
Battery and
Compartment
Figure 23. Replacing the Battteries
50
information@ITM.com
Maintenance
Cleaning the Calibrator
Clean the calibrator and pressure modules with a soft
cloth dampened with water or water and mild soap.
Service Center Calibration or Repair
Fuse
Calibration, repairs, or servicing not covered in this
Compartment
manual should be performed only by qualified service
personnel. If the calibrator fails, check the batteries first,
and replace them if needed.
sh38f.eps
Verify that the calibrator is being operated in accordance
with the instructions in this manual. If the calibrator is
faulty, send a description of the failure with the calibrator.
Pressure modules do not need to accompany the
calibrator unless the module is faulty also. Be sure to
Fluke-Direct
W
Warning
To avoid personal injury or damage to the
calibrator, use only the specified
replacement parts and do not allow water
into the case.
Caution
To avoid damaging the plastic lens and case,
do not use solvents or abrasive cleansers.
.ca
1.800.561.8187
Advertisement
Table of Contents
