Table of Contents
Advertisement
Calibrating a Pressure Transmitter
The following example shows how to calibrate a pressure
transmitter.
Connect the calibrator to the instrument under test as
shown in Figure 20. Proceed as follows:
l
1.
Press
l
press
U
2.
Press
3.
If necessary, press
4.
Zero the pressure module.
5.
Perform checks at 0 % and 100 % of span and adjust
the transmitter as necessary.
information@ITM.com
for current (upper display). If required,
again to activate loop power.
(lower display).
M
for SOURCE mode.
Fluke-Direct
Calibrating a Pressure Transmitter
.ca
1.800.561.8187
41
Advertisement
Table of Contents
