Fluke 725/FPC User Manual page 20

725
Users Manual
No Name
L L
AM OY
AM OZ
M XW
Y Z
N Q
O S
M
P
Q T
R V
S R
T U
12
information@ITM.com
Table 4. Key Functions (cont.)
Cycles through :
P
Slow repeating 0 % - 100 % - 0 % ramp
N
Fast repeating 0 % - 100 % - 0 % ramp
Repeating 0 % - 100 % - 0 % ramp in 25 % steps
Disables Shut Down Mode
Enables Shut Down Mode
Increases or decreases the source level.
Cycles through the 2-, 3-, and 4-wire selections.
Moves through the memory locations of calibrator setups.
In Contrast Adjustment mode; up-darkens contrast, down-lightens contrast.
Retrieves a previous calibrator setup from a memory location.
Saves the calibrator setup. Saves Contrast Adjust setup.
Cycles the calibrator through MEASURE and SOURCE modes in the lower display.
Selects TC (thermocouple) measurement and sourcing function in the lower display. Repeated pushes cycle through
the thermocouple types.
Toggles between voltage, mA sourcing, or mA simulate functions in the lower display.
Selects RTD (resistance temperature detector) measurement and sourcing function in lower display. Repeated pushes
cycle through the RTD types.
Selects the pressure measurement and sourcing function. Repeated pushes cycle through the different pressure units.
Fluke-Direct
Description
.ca
1.800.561.8187