Configure Your Machine For A Wireless Network When The Ssid Is Not Broadcast - Brother DCP-J572DW Online User's Manual

Home > Network > Additional Methods of Configuring Your Brother Machine for a Wireless
Network > Configure Your Machine for a Wireless Network When the SSID is Not Broadcast
Configure Your Machine for a Wireless Network When the SSID is Not
Broadcast
>> DCP-J572DW/MFC-J491DW
>> DCP-J772DW/MFC-J690DW/MFC-J890DW
DCP-J572DW/MFC-J491DW
Before configuring your machine, we recommend writing down your wireless network settings. You will need
this information before you continue with the configuration.
1. Check and write down the current wireless network settings.
Network Name (SSID)
Communication Mode
Infrastructure
For example:
Network Name (SSID)
HELLO
Communication Mode
Infrastructure
If your router uses WEP encryption, enter the key used as the first WEP key. Your Brother machine
supports the use of the first WEP key only.
2. Press Settings.
3. Press a or b to select the following:
a. Select [Network]. Press OK.
b. Select [WLAN]. Press OK.
c. Select [Setup Wizard], and then press OK.
4. When [Enable WLAN?] appears, press c.
The wireless setup wizard starts. To cancel, press d.
5. The machine will search for your network and display a list of available SSIDs. Press a or b to select the
[<New SSID>] option, and then press OK.
6. Enter the SSID name, and then press OK.
For more information about how to enter text, see the Appendix.
7. Select [Infrastructure], and then press OK.
8. Select the Authentication Method, and then press OK.
9. Do one of the following:
Authentication Method
Open System
Shared Key
WPA/WPA2-PSK
Authentication Method
WPA2-PSK
Encryption Mode
NONE
WEP
WEP
AES
TKIP
Encryption Mode
AES
Network Key
-
Network Key
12345678
353