Basic Recording
Adjusting the LCD during PLAY
You can adjust the LCD during playback.
The adjustment method is the same procedure as used in CAMERA mode. (see page 30)
Controlling Sound from the Speaker
The Speaker works in PLAYER mode only.
When you use the LCD screen for playback, you can hear the recorded sound from
the built-in Speaker.
- Follow the instructions below to decrease or mute speaker volume in the PLAYER mode.
- Take the following steps to lower the volume or mute the sound while playing a tape
on the PLAYER.
1. Set the power switch to PLAYER mode.
2. Press
(PLAY/STILL) to play the tape.
3. When you hear sounds once the tape is in play, use the MENU SELECTOR to adjust the volume.
A volume level display will appear on the LCD.
Levels may be adjusted from anywhere between 00 to 19 and you will not hear
any sound when the volume is set on 00.
You can adjust the headphone volume separately from the built-in speaker.
If you close the LCD while playing, you will not hear sound from the speaker.
Notes
Sometimes audio may sound distorted when the volume is turned up high.
If this happens, turn down the volume.
The speaker turns off when you use headphones.
ENGLISH
2
3-1
<3-2>
0 : 2 3 : 4 7
5 5 min
VOL.
[ 1 1 ]
20:00
1. JAN. 2002
33
33