Technical Data - Hilti DX 351 M&E Manual

Drawer
&
3.3 Intended use
The product described is a cartridge-actuated fastening tool for driving fasteners and composite fasteners
into concrete, steel and sand-lime block.
Use the product only in combination with the equipment designed for use with the fastening tool. Fastener
guides, pistons and fasteners must be compatible with one another.
Use the product only with spare parts and accessories from Hilti and with cartridges and fasteners from
Hilti, or other suitable cartridges and fasteners.
3.4 Requirements to be met by cartridges
WARNING
Risk of injury by unexpected explosion!
requirements can lead to a build-up of unburned powder. A sudden explosion and severe injuries to the
operator and bystanders can result.
▶ Use only cartridges that meet the minimum safety requirements of your local statutory regulations!
▶ Adhere to the maintenance intervals as stated and have the fastening tool cleaned regularly by Hilti-
Service!
Use only the Hilti DX cartridges listed in this table, or other suitable cartridges that are compliant with the
minimum safety requirements:
• It is a requirement for EFTA countries that the cartridges must be CE-compliant and must bear the CE
mark of compliance.
• It is a requirement for the United Kingdom that the cartridges must be UKCA-compliant and must bear
the UKCA mark of compliance.
• It is a requirement for the USA that the cartridges must be compliant with the stipulations set out in
ANSI A10.3-2020.
• It is a requirement for the non-European member states of the C.I.P. that the cartridges must have C.I.P.
approval for the DX fastening tool used.
• It is a requirement for the remaining countries that the cartridges must have passed the firing-residues
test in accordance with EN 16264 and must have a manufacturer's declaration to this effect.
Compatible cartridges
Ordering designation
6.8/11 M white
6.8/11 M green
6.8/11 M yellow
6.8/11 M red
3.5 Information about the field of applications
See the Hilti product page for more information about the areas of application.
4

Technical data

4.1 Product properties
Weight (basic tool)
Length (fastening tool)
Recommended maximum fastening
rate
Required contact pressure
Compression stroke
Ambient temperature (storage and
use)
*333018*
Use of cartridges that do not meet the minimum safety
DX 351 M&E
2.7 kg
545 mm
700 fastener driving opera-
tions/h
100 N
59 mm
−15 ℃ ... 45 ℃
333018
Magazine
(
Color
white
green
yellow
red
DX 351 MX
2.7 kg
545 mm
700 fastener driving opera-
tions/h
130 N
59 mm
−15 ℃ ... 45 ℃
Power level
Extra-weak
Weak
Medium
Strong
English 5