Operation; Bevel Cutting; Dust Cover - Makita 4326 Instruction Manual

Hex wrench storage
► 1. Hook 2. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Adjusting roller (For models 4326/4327)
1
► 1. Blade 2. Roller 3. Retainer 4. Hex wrench 5. Bolt
6. Base
Loosen the bolt on the back of the base with the hex
wrench. Move the retainer so that the roller contacts the
blade lightly. Then tighten the bolt to secure the base
and the retainer.
NOTE:
• Occasionally lubricate the roller.

Dust cover

1
► 1. Dust cover
1
2
3
2
4
5
CAUTION:
• Always wear safety goggles even when operat-
ing the tool with the dust cover lowered.
Lower the dust cover to prevent chips from flying.
However, when making bevel cuts, raise it all the way.

OPERATION

CAUTION:
• Always hold the base flush with the workpiece.
Failure to do so may cause blade breakage,
resulting in a serious injury.
• Advance the tool very slowly when cutting
curves or scrolling. Forcing the tool may cause a
slanted cutting surface and blade breakage.
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest
the base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.
1
6
► 1. Cutting line 2. Base

Bevel cutting

CAUTION:
• Always be sure that the tool is switched off and
unplugged before tilting the base.
• Raise the dust cover all the way before making
bevel cuts.
6 ENGLISH
2