Software Setting Mode - Epson TM-T20II Technical Reference Manual

Software Setting Mode

Starting the Software setting mode
Follow the steps below to run this mode.
1
Close the roll paper cover.
2
While pressing the Feed button, turn on the printer. (Keep pressing the
Feed button until the printer starts printing.)
The printer starts printing current status of the printer.
When the printer finishes printing the printer status, the following message is printed and
the Paper LED flashes. (The printer is now in the self-test wait mode.):
3
Press the Feed button for 1 second or more to enter the Mode Selection.
The printer starts printing instructions.
78
"Select Modes by pressing Feed button.
Continue SELF-TEST: Less than 1 second
Mode Selection:
Mode Selection
Modes
0 : Exit and Reboot Printer
1 : NV Graphics Information
2 : Receipt Enhancement Information
3 : Customize Value Settings
4 : or more: None
Select Modes by executing following
procedure.
step 1. Press the Feed button less
than 1 second as many times
as the selected mode number.
step 2. Press Feed button for 1
second or more.
1 second or more"