ABB UNO-DM-3.3-TL-PLUS Product Manual page 148

INVERTER RUN
N.C.
Relay State: Idle
N.O.
SELECTED
ERROR/WARNING
OCCURENCY
ERROR MESSAGE
t=15s
N.C.
Relay State: Switched
N.O.
GRID RECONNECTION
t=based on Country Standard
N.C.
Relay State: Idle
N.O.
ERROR/WARNING
Yes No
STILL
PRESENT
For the configurable relay operating mode "Alarm Conf.", the following considerations are
valid:
If the alarm condition is persistent, the alarm contact cyclically switches from its resting state
to its activated state.
In the presence of W002 signalling (Input UV – input voltage below the limit of operation),
the alarm contact switches to then reset itself at the end of the alarm signal. This means that
during the reduced input voltage (display message "Waiting Sun") the alarm contact remains
in its resting position.
In the presence of W003, W004, W005, W006, W007 signalling, the alarm contact switches
to then reset itself at the end of the alarm signal. This means that during the absence of grid
voltage (display message "Missing Grid") the alarm contact remains in its resting position.
• Configurable alarm with reset at the end of the alarm signalling
process (display text "Alarm Conf.")
The relay is activated (status: switched) whenever an error (code Exxx)
or a warning (code Wxxx) is present from those selected from the list in
the dedicated submenu Alarm Config. The contact returns to its resting
position when the alarm signal ends, i.e. before the inverter checks the
grid after the alarm state. This is because grid control state is not an
alarm state but a state of normal operation.
Selectable alarms for which the relay is activated
E001 E002
E007 E009
E014 E015
E020 E021
E026 E027
E032 E033
E046 E050
E057 E058
E089 W001
W006 W007
W047 W048
- 148 -
E003 E004 E005
E010 E011 E012
E016 E017 E018
E022 E023 E024
E028 E029 E030
E034 E035 E036
E053 E054 E055
E077 E078 E081
W002 W003 W004
W009 W011 W015
W051 W058 W059
7 - Operation
E006
E013
E019
E025
E031
E037
E056
E084
W005
W046