ABB UNO-DM-3.3-TL-PLUS Product Manual page 127

INVERTER RUN
N.C.
Relay State: Idle
N.O.
SELECTED
ERROR/WARNING
OCCURENCY
ERROR MESSAGE
t=15s
N.C.
Relay State: Switched
N.O.
GRID RECONNECTION
t=based on Country Standard
N.C.
Relay State: Switched
N.O.
ERROR/WARNING
Yes No
STILL
PRESENT
• Latch configurable alarm - display text "Alarm-Contact (alarm con-
figuable - latch)":
The relay is activated (status: switched) whenever an error (code Exxx)
or a warning (code Wxxx) is present from those selected from the list in
the dedicated submenu Alarm Config of the inverter display (see the
table below). When the inverter returns to the normal operating state and
reconnects with the grid.
Selectable alarms for which the relay is activated
E001 E002
E007 E009
E014 E015
E020 E021
E026 E027
E032 E033
E046 E050
E057 E058
E089 W001
W006 W007
W047 W048
If the alarm condition is persistent, the relay will remain activated
(status:switched)
• Ext configurable alarm - display text "Alarm-Contact (alarm con-
figuable - matrix)":
In this mode, it is possible to configure the behaviour of the alarm relay
according to an external error table which can be setup with the Aurora
Manager LITE software. In the table it is possible to select the alarms
or warnings for which the alarm relay is activated (status: switched); for
each individual alarm it is also possible to select the "Latch" or "No Latch"
mode.
- 127 -
E003 E004 E005
E010 E011 E012
E016 E017 E018
E022 E023 E024
E028 E029 E030
E034 E035 E036
E053 E054 E055
E077 E078 E081
W002 W003 W004
W009 W011 W015
W051 W058 W059
7 - Operation
E006
E013
E019
E025
E031
E037
E056
E084
W005
W046