Advertisement
RTV 900 Soft Top Installation (continued)
5.
Locate the strap on the driver side at the front
cross bar of the ROPS. Fasten around the bar.
Repeat this step for the passenger side of the top.
6.
Locate the straps running down the length of the
rear vertical ROPS bar. Fasten around the bar. Repeat
this step for the opposite side.
Tip – A good way to get the straps tight is to rotate the top
around the bar like in the picture on the right.
7.
Locate the large straps that run front to rear and
fasten them.
Tip – Fasten them above the support straps, as shown, for
more head room.
8.
Pull the front of the cab down until it is taut and
level. Place the 2" adhesive velcro squares as
shown on the front corner of the ROPS just below
the bend. This holds the front corners of the top
in place. Repeat on both sides.
Advertisement
