Set Up Instructions - Stamina AVARI 2000E Elliptical Trainer Owner's Manual

SET UP INSTRUCTIONS

Place the AVARI® 2000E Elliptical Trainer in the area where it will be used. It is recommended that the
AVARI® 2000E Elliptical Trainer be placed on an equipment mat. The maximum operation dimensions of
the AVARI® 2000E Elliptical Trainer are approximately 52.6 inches long x 25.4 inches wide x 57 inches
tall. (These dimensions may vary up to one inch.) Make sure that adequate space is available for access
to passage around and emergency dismount from the AVARI® 2000E Elliptical Trainer. A minimum of 20
inches on at least one side and 20 inches either behind or in front of the AVARI® 2000E Elliptical Trainer
is required for safe operation.
LEVELING: Turn the dials in the ADJUSTABLE ENDCAPS(81) which are attached to the REAR
STABILIZER(2) so that the AVARI® 2000E Elliptical Trainer sits on the floor without
rocking.
MOVING: The AVARI® 2000E Elliptical Trainer has a pair of wheels built into the LEFT and RIGHT
ENDCAPS(100, 101) at the front. Grasp the STATIONARY HANDLEBAR(11) and tip the
AVARI® 2000E Elliptical Trainer forward to move.
FUNCTION INSPECTION:
Visually inspect the AVARI® 2000E Elliptical Trainer to verify that assembly is as shown in the above
illustration. Check the function of the AVARI® 2000E Elliptical Trainer, stand on the foot pedals and place
your hands at a comfortable position on the handlebars. Slowly move your highest foot forward and follow
the natural path of the machine. Turn the crank slowly through one complete revolution to verify that the
drive train functions properly. Adjust the TENSION KNOB(22) and verify that it functions properly.
CAUTION: Locate and read the WARNING LABEL(95) on the AVARI® 2000E Elliptical Trainer. Make
sure that all users read the WARNING LABEL(95) before using the product.
Dial
Equipment Mat
Dial
13