5-11 Sas/Sata Ports; 5-12 Installing Software - Supermicro 6028R-E1CR12N User Manual

S S S
UPER TORAGE YSTEM 6028R-E1CR12N User's Manual

5-11 SAS/SATA Ports

SAS Ports
An LSI 3108 controller card is included in the system to support up to 240 SATA
3.0/SAS 3.0 hard drives.
SATA Ports
There are ten SATA 3.0 ports included on the serverboard. Six ports (I-SATA
0-5) are supported by the Intel PCH C612 while the other four (S-SATA 0-3) are
supported by the Intel SCU. These ports provide serial-link signal connections,
which are faster than Parallel ATA.
Note: For more information on SATA HostRAID configuration, please refer to the
Intel SATA HostRAID User's Guide posted on our website at http://www.supermicro.
com..
5-26

5-12 Installing Software

The Supermicro ftp site contains drivers and utilities for your system at
supermicro.com. Some of these must be installed, such as the chipset driver.
After accessing the ftp site, go into the CDR_Images directory and locate the ISO
file for your serverboard. Download this file to create a CD/DVD of the drivers and
utilities it contains. (You may also use a utility to extract the ISO file if preferred.)
Another option is to go to the Supermicro website at
products/. Find the product page for your serverboard here, where you may down-
load individual drivers and utilities.
After creating a CD/DVD with the ISO files, insert the disk into the CD/DVD drive
on your system and the display shown in Figure 5-6 should appear.
Figure 5-6. Driver/Tool Installation Display Screen
Note: Click the icons showing a hand writing on paper to view the readme files
for each item. Click the computer icons to the right of these items to install each
item (from top to the bottom) one at a time. After installing each item, you must
re-boot the system before moving on to the next item on the list. The bottom
icon with a CD on it allows you to view the entire contents.
Chapter 5: Advanced Serverboard Setup
ftp://ftp.
http://www.supermicro.com/
5-27