Understanding The Status Leds - ADTRAN 617600028F1 Quick Start Manual

854-6/v6 service delivery gateway
Table of Contents

Advertisement

3. For a Voice connection on the 854-v6 only, insert an RJ-11 cable into one of the telephone ports (labeled Tel 1 or Tel 2) until there is an audible
"click".
4. Before connecting to the service provider interface, clean the optical Interfaces of the SC/APC connectors.
5. Insert the fiber cable into the WAN port on the bottom of the gateway.
f
CAUTION!
To prevent breaking the fiber, do not exceed the fiber bend radius of 3.5 in (8.9 cm).
Connecting the Power Supply
1. Connect the end of the power adapter to the Power port on the rear panel of the gateway
2. Plug other end of the power adapter into the wall outlet.
3. Confirm that the power is connected properly. The Power LED should be lit on the front of the gateway.
g
NOTE
Alternately, the device may be powered by a supported third-party UPS which may be connected via 7-pin molex connector, labeled UPS.
Resetting the Gateway
A reset button is available if the device needs to be rebooted. To reboot the device, press the Reset button on the rear panel of the gateway for 5 seconds
or less. To reset the device to custom defaults, press the Reset button for 5 seconds or more.

Understanding the Status LEDs

The LEDs on the back panel of the device enable you to monitor the device status. This section describes the four types of LEDs available on the
gateway. See Figure 3 for details.
Fiber Status LED
The Fiber status LED indicates the state of an inserted Fiber SFP module.
LED
Color
Green
Fiber
None
2.5G WAN LED
The 2.5G WAN status LED indicates the state of the 2.5G WAN connection on the gateway.
LED
2.5.Gbps
WAN
1000/
100 Mbps
4
State
Description
On
Fiber optic connection is UP.
Flashing
Fiber optic connection is discovering or activating the ONT on the PON.
Off
Fiber optic connection is DOWN.
Color
State
Description
On
WAN is UP at 2.5 Gbps speed.
Green
Flashing
WAN connection is transferring data.
Orange
On
WAN is UP at 1000/100 Mbps speed.
Flashing
WAN connection is transferring data.
None
Off
WAN connection is DOWN.
Figure 3. Status LEDs
617600132F1-13A

Advertisement

Table of Contents
loading

This manual is also suitable for:

617600026f1

Table of Contents