Installation And Set-Up - Vents MICRA 100 E User Manual

• The heat exchanger overheating protection in unit models without a pre-heater is achieved by automatic supply fan speed reduction
according to extract air sensor readings.
• The extract fan runs at maximum speed.
• Temperature differences between supply and extract air flows in the units with polystyrene heat exchangers lead to condensate
formation. Condensate is collected in the drain pan and is removed outside by the drain pipes through the exhaust air duct.
Condensate is not forming in the units equipped with an enthalpy heat exchanger as moisture is transferred from one airflow to
another through the membrane.
• The louvre shutters open automatically when the motors are switched on and close when the motors are switched off.
*An additional extract spigot can be fitted to the unit to connect the exhaust air duct from additional premises, e.g. a bathroom. The
spigot is included in the delivery set.
EXTRACT AIR
INTAKE AIR
EXHAUST AIR
www.ventilation-system.com
SUPPLY AIR
READ THE USER'S MANUAL BEFORE INSTALLING THE UNIT.
WHILE INSTALLING THE UNIT ENSURE CONVENIENT ACCESS FOR SUBSEQUENT
Minimum distances from the unit to the surfaces
min 300 mm
EXTRACT AIR
Extract spigot*
INTAKE AIR
MAINTENANCE AND REPAIR.
min 300 mm
SUPPLY AIR
EXHAUST AIR

INSTALLATION AND SET-UP

7