Install The Hood (Ez1 Brackets) - Kenmore 51282 Series Use & Care / Installation Manual

Hide thumbs Also See for 51282 Series:

Use & care / installation manual (32 pages)

Table of Contents

Available languages

NOTE: The following procedure applies to both

framed or frameless cabinet installations.

1. Run house power cable between service panel and

hood location.

2. There are 2 pairs of recessed holes on each side

of the top of the hood (on rear: A and B, on front

C and D on illustration below); these holes allow

the range hood to hang on the brackets (previously

installed).

HORIZONTAL EXHAUST INSTALLATION ONLY

3. Temporarily hang the hood on the brackets using its

2 recessed REAR HOLES (A and B). While holding

the hood, run the house power cable into the hood

through the strain relief previously installed

on page 8.

4. Unhook the rear holes from the brackets and hang

the hood using its 2 recessed FRONT HOLES (C and

D). While holding the hood, attach the power cable

to the hood using the strain

VERTICAL EXHAUST INSTALLATION ONLY

5. Hang the hood on the brackets using the 2 recessed

FRONT HOLES (C and D). While holding the hood,

run the house power cable into the hood through

the strain relief previously installed in step 5 on

page 8. Attach power cable to the hood.

6. Connect the ductwork to the hood and use metal foil duct tape to make joints secure and air-tight. Make sure

the damper assembly (or round duct plate) enters the ductwork and that the damper opens and closes freely.

7. For framed cabinet, secure the hood to the EZ1

brackets using 4 no. 8-18 x 1/2" metal screws with

washers (screws and washers included in parts

bag). Insert 2 screws and washers per side, in the

slots (as shown in inset on illustration beside).

8. For frameless cabinet, secure the hood to the

cabinet using 4 no. 8 x 5/8" round head wood

screws (screws and washers included in parts bag).

Insert 2 screws and washers per side, in the slots (as

shown in inset on illustration beside).