Install The Hood - Kenmore 233.5817 Series Use & Care / Installation Manual

VERTICAL DISCHARGE
HO0082
8. Using 2 no. 6 x 1/2'' screws, assemble the adapter/damper to the hood.
NOTE: Damper fl ap pivot (1) to the front of the hood for vertical discharge and for horizontal discharge,
damper fl ap pivot to top of hood.
HO0083
9. Seal the adapter/damper to the hood using duct tape.
1. Run power cable to installation location. Position the hood in its intended location. Using a pen, mark the position
of the screws (smaller part of the keyhole, see picture below for the 5 keyhole locations). Remove the hood.
Install 4 no. 8 x 1/2'' screws, leaving a 1/8'' gap. Do not install the no. 5 screw yet.
HD0168
2. Attach the wire clamp, insert the power cable in the hood and tighten the wire clamp to secure the cable. Place the
hood under the cabinet and slide it in position. Make sure the adapter/damper assembly enters the duct opening.
Tighten the 4 screws completely, then add the last screw (screw no. 5) in the center keyhole. Make sure the damper
fl ap opens freely.
PREPARE THE HOOD
1

INSTALL THE HOOD

1
2
10
HORIZONTAL DISCHARGE
HO0084
HO0085
5
1
4
3