Water Supply And Drain; Connection Of Drain Hoses - Euromaid EDW6014X User Manual

Water Supply and Drain

Cold water connection
• Connect the cold water supply hose to
inch
a threaded 3/4
sure that it is fastened tightly in place.
• If the water pipes are new or have not
been used for an extended period of time,
let the water run to make sure that the
water is clear. This precaution is needed
to avoid the risk of the water inlet to be
blocked and damage the appliance.
Close the hydrant after using.

Connection of Drain Hoses

Insert the drain hose into a drain pipe with a minimum diameter of 4cm,
or let it run into the sink, making sure to avoid bending or crimping it.
The height of drain pipe must be less than 1000mm. The free end of
the hose must not be immersed in water to avoid the back flow of it.
Warning!
Securely fix the drain hose in either position
Back of dishwasher
Mains Cable
INSTALLATION
connector and make
Drain hose
Water Inlet
Drain Pipe
A or position B.
A
B
14
Counter