Safety Instructions; Changing The Program Mid-Cycle; Add A Dish During A Cycle - Euromaid EDW6014X User Manual

Staring a Wash Cycle
Draw out the lower and upper basket, load the dishes and push them back.
1
It is recommended to load the lower basket first, then the upper one.
Pour in the detergent.
2
Insert the plug into the socket. For the power supply refer to last page
3
specifications. Make sure that the water supply is turned on to full pressure.
Close the door, press the power button
4
Choose a program, the response light will turn on,
5
Press the start/pause button

Changing the Program Mid-Cycle

A wash cycle can only be changed if it has been running for a short time otherwise,
the detergent may have already been released and the dishwasher may have already
drained the wash water. If this is the case, the dishwasher needs to be reset and the
detergent dispenser must be refilled. To reset the dishwasher, follow the instructions below:
Press the start/pause button
1
Press program button
2
Press the program button
3
Press the start/pause button
4

Add a Dish During a Cycle

A forgotten dish can be added any time before the detergent dispenser opens.
If this is the case, follow the instructions below:
Press the start/pause button
1
Wait 5 seconds then open the door.
2
Add the dishes.
3
Close the door.
4
Press the start/pause button
5
Warning! It is dangerous to open the door mid-cycle, as hot steam may scald you.
DAILY USE
, to switch on the dishwasher.
, the dishwasher will start its cycle.
to pause the washing.
P for more than 3 seconds, the program will cancel.
P to select the desired program.
, after 10 seconds, the dishwasher will start.
to pause the washing.
after 10 seconds, the dishwasher will start.
32
technical
.