Water Connection; Connect Water Inlet Hose - Euromaid DW24S Instruction Manual

Water connection

•
Your dishwasher has cold water
inlet hose (up to 25°C)
•
The dishwasher may not be
connected to open warm water
devices or flow-through water
heaters.
Permitted water pressure:
Lowest permitted water pressure: 0.3
bars = 3 N/cm² = 30 kPa
When the water pressure is below 1
bar, please contact your technician.
Highest permitted water pressure: 10
bar = 100N/cm² = 1Mpa
When the water pressure is above 10
bars, a pressure reduction valve must
be installed (available in trade supply
stores).

Connect water inlet hose

Ensure that the water inlet hose is not
bent or squeezed. Do not install a used
hose set.
Use a screw-on hose connector to
connect the water inlet hose to a water
tap with a ¾ inch external thread. If
required, use a filter insert to filter
deposits from the pipes.
Check that the connection does not
leak.
Important
For safety reasons, turn off the tap
after every rinse process.
1009
AQUASAFE+ (some models)
The Aquasafe+ System protects
against water damage hich may be
caused at the water inlet hose.
Do not immerse the system's valve
box into water; it contains electrical
components.
In case of damage, pull out the power
supply plug.
Do not shorten or lengthen the hose
insert as it contains electrical cables
and components.
����
7 GB
������
1010
���������