Rebooting The Mk22X0 - Motorola Symbol MicroKiosk MK22 0 Series Reference Manual

3 - 4 MK22X0 Series MicroKiosk for CE .NET 4.2 Product Reference Guide

Rebooting the MK22X0

After downloading the mkconfig.reg file, perform a remote or local cold boot to apply the new settings.
Remote Boot
After loading the configuration file onto the MK22X0 using the wired or wireless Ethernet connection, use the RDM
to send a command over the network to initiate a remote cold boot of the MK22X0.
Select the MK22X0 to cold boot from the list box in the
1.
From the RDM main toolbar, select
2.
reboot and reconnect, then select
Local Boot
To manually cold boot the MK22X0, which enables the settings within the mkconfig.reg file to load, press and hold
buttons B and C on the MK22X0 (see
then release the buttons.
Remote Device Manager
. Allow approximately one minute for the MK22X0 to
Actions > Cold Boot
to verify the device rebooted successfully.
View > Refresh
Figure 1-1 on page 1-2) until the display goes blank (typically 15 seconds),
screen.