BYK micro-gloss 60 S Quick Start Manual

Measure what you see.

Operation

operate
Main menu
Mode
Geometry/Sensor
Memory/Organizer
Difference
Calibration
Setup
Please note: The software smart-chart for data analysis
and the detailed operating manual are available for
download from the support section at:
www.byk.com/instruments
BYK-Gardner GmbH · Lausitzer Strasse 8 · 82538 Geretsried · Germany · Tel. +49-8171-3493-0 · Fax +49-8171-3493-140 · www.byk.com/instruments
A member of
mode wheel:
• Switch on
• Show menu
• Select function
• Activate function
operate-button:
• Measure
Navigation Symbols:
¢
¢ Back to previous menu
}
} Got to sub-menu
}
3 Function activated
}
* Guide to language menu
}
}
*}

How to calibrate?

Gloss
press
press
Autodiagnosis
scroll
press
Please clean standard
Confirm ¢
Cancel ¢
Note: Do not clean the standard with acetone!
For cleaning information see operating manual.
Thickness (only micro-TRI-gloss μ)
Main menu
Calibration
Calibrate
Thickness Fe
Thickness NFe
*It is advisable, to perform the zero calibration on the uncoated
metal of the sample to be tested.
• Turn on the unit in holder
• Autodiagnosis checks standard
and calibration
• If requested, clean the standard
and start calibration by pressing
[mode]
the mode wheel
[operate]
• Select the desired sensor
(Fe or NFe)
}
• Put the unit on the zero
standard or original substrate*
}
• Press operate button
}
• Hold the unit free in air and
press operate
}
Additives & Instruments