Network Cables - NEC SIGMABLADE Series User Manual

Network Cables

Your network cables must have the following specifications:
N8406-011 1Gb Pass-Through Card
Connector
Type of Cable
Regulation
Cable length
(max.)
This product supports 1000Mbps/Full Duplex only.
N8406-021 FC Pass-Through Card and N8406-015 FC SFP Module
Connector
Type of Cable
Cable Length
Only technically qualified personnel must install optical fiber cables. Contact
your service representative for cabling.
Handle optical fiber cables with care.
Be sure to allow for a 50mm minimum bending radius.
Do not force the cable connector into the slot. Align the connector at a right
angle. You can insert it smoothly if you align it properly.
Make sure that the surface of the optical fiber cable connector is clean and not
damaged.
To avoid miscabling, make sure that your cable meets the specification required
and that you connect the cable to a correct destination connector.
Do not drop the fiber optical cable. Do not allow the connector to make contact
with any surface, such as a floor.
Do not give any impact or pressure to the cable and its connector while it is
connected. To avoid damage to the cable, do not step on the cable or place
something heavy on it.
Do not force the cable connector into the slot. If you damage the end of the
cable, it may lower optical output and cause the cable to malfunction.
RJ-45
UTP/STP twisted-pair cable
Eight wicks, four pairs
1000Base-T
100m
LC Connector
Multi-Mode Fibre (MMF) cable
Core size: 50µm
150m (when the core size is 50µm.)
EIA/TIA standard
Category 5e or higher
(English)
31