NEC SIGMABLADE Series User Manual page 21

Precautions for Installation, Relocation, Storage and Connection
Do not put your hand inside Blade Enclosure.
When you are attaching/detaching the card to Blade Enclosure, do not put your hand
inside Blade Enclosure. Doing so may cause an electrical shock. Do not remove
the cover attached to Blade Enclosure unless you are attaching the device to it.
Use the card only in specified places
This card is used in the dedicated machine called Blade Enclosure. Do not attach
the card to any machine other than Blade Enclosure or other cases as doing so may
cause a fire or an electrical shock.
Do not block the air openings
Do not block the air openings. When they are blocked, the interior temperature will
increase and may cause a fire.
Do not use any non-designated interface cable
Use conforming interface cables and check the connection devices and the
connectors. Using unspecified cables or connecting to wrong places may cause a
short circuit or a fire.
Follow the precautions shown below for handling interface cables and their
connections.
•
Do not use damaged cable connectors
•
Do not step on cables
•
Do not put any object on cables
•
Do not use the card with the loose interface cable connection
•
Do not use damaged cables
Never use or keep in the corrosive gas environment
Do not use or keep in the corrosive gas, such as sulfur dioxide, hydrogen sulfide,
nitrogen dioxide, chlorine, ammonia, ozone, environment.
Do not set the device up in the environment where electro conductive metals, such
as sodium chloride and sulfur, are present in dust and air.
The printed circuit board in the device may corrode and start fuming or a fire.
Contact the place of purchase or the maintenance service company if you have
questions about the environment.
WARNING
CAUTION
Precautions for Use
xiii