Table of Contents
Advertisement
7.2. Network Cables
N8104-206/207
Connector
Type
Cable Category
Length
Limitation of N8104-206/207
The width of the root portion of a plug should
Refer to the left figure which does not get used to use for the cable with boots (with a connector cover).
* The cable with boots causes of poor contact and a connector breakage.
N8104-208
A "N8104-189 SFP+ module (10G-SR)" has an optical fiber interface based on IEEE802.3ae 10Gigabit
Ethernet® standard. The 10GbE SR standard enables 10GbE and full duplex transmissions at distances
up to 300 meters using standard multi-mode fiber (MMF, 850nm wave length) cabling.
Supported MMF cable listed below:
Connector type: LC
core/clad diameter
50/125μm
62.5/125μm
OM: Optical Multimode
RJ45
Twisted Pair Cable( UTP / STP ) Must be 4pair wiring
Make sure you use cable that complies with the TIA-568 wiring
specification.
10BASE-T: Cat.3 or better,
100BASETX : Cat.5 or better
1000BASE-T Cat.5e or better
100 m (max.)
less than12mm
11.58～11.79mm
based on ISO standard.
use the cable within 12mm.
cable boots
Modal bandwidth
400MHz*km
500MHz*km
2000MHz*km
160MHz*km
200MHz*km
Type
OM-2
OM-2
OM-3
OM-1
OM-1
E-19
Cable length
2～66 m
2～82 m
2～300 m
2～26 m
2～33 m
Advertisement
Table of Contents
