Asynchronous Side-By-Side - Projectiondesign F85 User Manual

6.4.4 Asynchronous side-by-side

35
In asynchronous side-by-side 3D, the projectors utilize the BNC sync-in and sync-out con-
nectors to distribute a system wide display sync. This display sync is used by all projectors
to perform frame rate conversion on the input signals if necessary. Figure 6-4 illustrates this
setup.
Figure 6-4. Asynchronous side-by-side setup
As seen in Figure 6-4, an extra cable is connected between BNC sync-out on projector 1
and BNC sync-in on projector 2. In this setup the projectors need the settings in the table
below to send/utilize the display sync correctly.
SETTING
3D
3D L/R sync
3D BNC sync-out signal
PROJECTOR 1 PROJECTOR 2
Side-by-side Side-by-side
Source BNC sync-in
3D display L/R sync Pass through
www.projectiondesign.com