Configuring 3D (As3D) - Projectiondesign F85 User Manual

5.14 Configuring 3D (AS3D)

F85 user's guide - Basic setup User's Guide - Basic setup
The projector has support for AS3D. AS3D images require active shutter glasses to work. To
enable active stereo select 3D > 3D MODE. Enabling 3D mode will configure the projector for
the use with an active stereo source.
The only active stereo 3D format natively supported by the projector is sequential left/
right at a frequency between 100 and 120 Hz. Both DVI and HDMI connectors can be
used for sources up to 165 Mhz. For sources between 165 and 330 Mhz, only DVI dual
link is supported.
After enabling stereo mode, configure the glass type being used by selecting 3D > 3D
GLASSES TYPE. The follow glasses are support:
• IR
• IR high brightness (may cause crosstalk)
When using IR glasses it is important to configure the phase delay between the glasses
and actual image. This is done using 3D > 3D LOCK PHASE DELAY with values 0 and 179
degrees.
If left/right data channels are swapped there will be no 3D effect in the image, only parallel
distortion between the channels. This can be countered by enabling the 3D > SWAP EYES
feature.
28