Multi-Channel 3D Synchronization - Projectiondesign F85 User Manual

6.4 Multi-channel 3D synchronization

6.4.1 Synchronous frame sequential
6.4.2 Asynchronous frame sequential
33
X-PORT DCC120 has advanced capabilities for handling synchronization of multiple projec-
tors in a 3D installation.
A typical synchronous frame sequential 3D setup is shown in Figure 6-2.
Figure 6-2. Synchronous frame sequential 3D
In this case IGs are synchronized and 3D sync from the source is connected from the DIN
connector on the IG to the BNC sync-in connector. The source 3D sync is then sent to every
projector in the setup. See table below.
SETTING
3D
3D L/R sync
3D BNC sync-out signal
This mode is not supported.
PROJECTOR 1 PROJECTOR 2
Frame sequential Frame sequential
BNC sync-in BNC sync-in
Pass through Pass through
www.projectiondesign.com