Electrical Connections; Power Supply; Control Boxes; Installation Of Control Unit Brackets - Hardi RANGER 2000 Instruction Book

Table of Contents

4 - Sprayer setup

Electrical connections

Power requirement is 12V DC. Note polarity! The wires must be at least

10 awg. (4.0 mm²) to ensure a sufficient power supply. For the operating

unit, the tractor circuit should have an 8 Amp fuse. The supplied power

connector is standard on most newer tractors. If using a tractor with a

different power connector, it is necessary to disassemble connector and

attach the wires to the actual tractor connector.

Control boxes are fitted in the tractor cabin at a convenient place.

Spray control unit requires:

Wire 12 awg, fuse 10 Amp

Hydraulic control unit requires:

Wire 10 awg, Fuse 15 Amp

The supplied tractor pillar bracket (A) has a hole spacing of 3.9 in.

(100mm) and 4.7 in. (120mm). Check tractor instructions manual for

information regarding attachment points.

Three tubes (B) are supplied. One, two or all 3 may be used. They can be

bent and shortened. A spacer (C) is also supplied to allow further

attachment possibilities. Find the best solution for your tractor or

vehicle.

Tube (B) plate is staggered, so if correctly orientated, all boxes will line

up.

Find a suitable place in the tractor's cabin. Best recommended

placement is to the right of the driver seat and in combination with the

Hydraulics control unit. It should be secured from movement.

ATTENTION! Tractor driver's seat is the intended working place

during operation.

4.6

Table of Contents