Repair Instructions; Dismantling The Starter; Cleaning And Inspection - Husqvarna 560XPG Workshop Manual

7.1 Dismantling the starter

1. Loosen the four screws, which hold the starter
against the crankcase and remove the starter.
2. Pull the cord out about 30 cm and lift it into the
notch on the outside of the starter pulley.
Release the tension in the return spring by
letting the starter pulley rotate anti-clockwise.
See figures 1 and 2.
WARNING!
If the spring tension is activated on
the starter pulley, the spring can fly
out and cause personal injury. Wear
protective glasses.
3. Loosen the screw in the centre of the pulley and
remove the pulley. See figure 3a. Loosen the
screws on the cassette and remove the
cassette and spring.

7.2 Cleaning and inspection

Clean the parts and check:
• The starter cord.
• That the starter pawls on the flywheel are intact,
i.e. that they spring back to the centre and move
easily.
• To lubricate the return spring using light oil.

7 Repair instructions

Fig 1
Fig 2
Fig 3a
Repair Instructions
19
English -