Fitting On The Saw - Husqvarna 560XPG Workshop Manual

Repair Instructions

7.26 Fitting on the saw

1. Press the connector together as outlined in
figure 44 and push it into place in the holder.2
2. Make sure the cabling is fitted to its mounting
on the intake flange.
Press the fuel hose C in place in the collar on
the intake bellows.
Hook on the throttle cable D in its mounting on
the intake bellows. See figure 46.
Make sure the lug on the carburettor hooks in
place on its mounting on the intake system.
Make sure that the following components are
correctly fitted:
• Position the air filter holder against the carburettor.
• Make sure the carburettor cover's intake channel
is aligned correctly with the slot for the air filter
holder.
• The spring must be fitted under the choke pin on
the carburettor. See figure 47.
• The rubber collar on the stop button must be on
the inside of the bottom of the carburettor com-
partment. See figure 47.
NOTE!
Make sure that the fuel and return hoses are
not crushed.
36
- English
Fig 44
Fig 45
C
Fig 46
D