Husqvarna 560XPG Workshop Manual page 32

Repair Instructions
6. Use a small flat screwdriver to snap open the
connector from the black attachment. Separate
the connector by pressing down the catch with
a flat screwdriver and then pulling the unit
apart. See figure 37
7. .Dismantle the metering cover G and carefully
remove the control diaphragm H and gasket I.
See figure 38.
8. Unscrew screw L and remove needle valve K
with lever arm M, shaft J and spring N. See
figure 38.
9. Use a needle or similar device and carefully pull
up the fuel screen S. See figure 39.
10. If necessary, dismantle throttle valve P and
choke valve Q and air valve O, and remove the
shafts with lever arms and springs (see figure
39).
11. If necessary, dismantle the AutoTune X unit.
See figure 39.
32
- English
Fig 37
J
K
L
Fig 38
G
H
I
M
N