Table of Contents
Advertisement
mode.
(7)Click Save to save the settings.
Day/Night Scheduled-Switch
(1)Draw the detection area as in the normal configuration mode. Up to 8 areas are
supported.
(2)Select Scheduled-Switch for Switch Day and Night Settings.
(3)Select the start time and the end time for the switch timing.
(4)Select the area by clicking the area No.
(5)Slide the cursor to adjust the sensitivity and proportion of object on the area
for the selected area in the daytime.
(6)Slide the cursor to adjust the sensitivity and proportion of object on the area
for the selected area at night.
(7)Set the arming schedule and linkage method as in the normal configuration
mode.
(8)Click Save to save the settings.
6.6.2 Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm when the lens is covered and take
some certain alarm response actions.
Steps:
1. Enter the video tampering Settings interface:
Configuration > Advanced Configuration > Basic Event > Video Tampering
Explosion Proof Network IP Camera User Manual
Figure 6-50 Day/Night Scheduled-Switch
88
Advertisement
Table of Contents
