Table of Contents
Advertisement
Mirror
Rotate: Rotate rotates the image +90 degrees. Rotate and Mirror can be used to
adjust the image in any orientation.
Video Standard: Select 60 Hz for NTSC format.
Capture Mode: To make a complete use of the 16:9 aspect ratio, you can enable the
capture mode when you use the camera in a narrow view scene.
Other: Options in this menu depend on the features of the camera.
—
Camera
EXPCMR-IP-POE-2MP-IR-108D
Image Sensor:
1/2.8" Progressive Scan CMOS
Signal System:
NTSC
Color: 0.005 lux @(F1.2, AGC ON),
Min. Illumination:
0 lux with IR
Shutter time:
1/3 s to 1/100,000 s
Slow shutter:
Support
Lens:
Lens Mount:
M12
Adjustment Range:
Pan: 0° to 360°, tilt: 0° to 90°, rotate: 0° to 360°
Day& Night:
Wide Dynamic Range:
120 dB
Digital noise reduction:
3D DNR
Compression Standard
Main stream: H.265/H.264,
Video Compresion
Sub stream: H.265/H.264/MJPEG,
Third stream: H.265/H.264
H.264 Type
H.264+
Supports
H.265 Type
H.265+
Supports
Video bit rate:
32 Kbps~16 Mbps
Image
Max. Image Resolution:
1920 × 1080
60 Hz: 30 fps (1920 × 1080, 1280 × 960,
Main Stream:
1280×720)
Sub Stream:
60 Hz: 30 fps (640 × 360, 352 × 240)
60 Hz: 30 fps (1920 × 1080, 1280×720,
Third Stream:
640 × 360, 352 × 240)
Image Enhancement:
BLC/3D DNR
Rotate Mode, Saturation, Brightness, Contrast, Sharpness adjustable by client software or
Image Settings:
web browser
Region of Interest (ROI):
Day/Night Switch:
Auto/Scheduled
Network
Network Storage
Support microSD / SDHC / SDXC card up to 128GB local storage, NAS (NFS,SMB/CIFS), ANR
Alarm Trigger
HDD full, HDD error
TCP/IP, UDP, ICMP, HTTP, HTTPS, FTP, DHCP,
DNS, DDNS, RTP, RTSP, RTCP, PPPoE, NTP,
Protocols:
UPnP, SMTP, SNMP, IGMP, 802.1X, QoS,
IPv6, Bonjour
General Functions
System Compatibility:
Interface
Communication
1 RJ45 10M/100M Ethernet interface
Interface:
In-camera storage:
Built-in microSD / SDHC / SDXC slot, up to 128GB
Smart Features
Line crossing detection, Intrusion detection, Unattended baggage detection, Object removal
Behavior Analysis
detection
4
www.larsonelectronics.com
Camera
EXPCMR-IP-POE-2MP-IR-108D
Line Crossing Detection
Intrusion Detection
supported
Unattended Baggage
Object Removal
Face Detectionn
Human face appears in the image can be detected and trigger linkage method
General
Operating Conditions:
-22 °F ~ 140 °F (-30 °C ~ 60 °C), Humidity 95% or less (non-condensing)
12 Vdc ± 25%, 5 W,
Power Consumption:
PoE (802.3af, 42.5 – 57V, class 3), 6.5 W
Weather Proof:
IP67
IR Range:
Up to 120 ft (approx. 35 m)
Using the Waterproof Ethernet Fitting
Install the Waterproof Ethernet Fitting on the Enternet cable end at the camera when moisture
1.
Place the rubber O-ring over the camera drop cable end cap.
Push the O-ring up to the connector cap.
2.
If the network cable from the switch or router has a connector
3.
Place the Lock Nut onto the network cable from the router
or switcn as shown in the drawing to the right. The inside
threads must be toward the camera end.
4.
Place the rubber basket onto the network cable above the lock
nut as shown.
5.
Place the end cap onto the network cable above the rubber
router or switch.
6.
Install an RJ-45 connector onto the network cable.
7.
Plug the RJ-45 connector with the network cable into the
camera network drop cable.
8.
Fit the end cap on the network cable onto the camera drop
cable end cap. Rotate the network cable end cap to lock it in
place.
9.
Push the rubber gasket fully into the end of the network cable
end cap.
10.
Screw the lock nut onto the network cable end cap until it is
fully seated.
Waterproof Ethernet Fitting assembed and connected
QR PLACE
HOLDER
RECOMMENDED APP
QR Code Reader
Network drop
cable from
camera
Drop cable
end cap
Rubber
O-ring
seal
RJ-45
connector
End cap
Rubber
gasket
Lock nut
Network
cable
from
router or
switch
COMPLETE MANUAL
SCAN THE QR CODE TO VIEW THE
COMPLETE MANUAL FOR THIS
PRODUCT
Load a QR Code Reader
1
App on your Smartphone.
Start the QR Code
2
Reader App.
Scan the code on the left
3
with your Smartphone.
By Scan, Inc.
EXPCMR-IP-POE Series
Advertisement
Table of Contents
