AIR-EAGLE
900 MHz RF Transmitter
MODEL 44-1200-BAT
DESCRIPTION
The A
-E
XLT
44-1200-BAT, is an R.F. transmitter
IR
AGLE
MODEL
designed to send a single stop command to any Air-Eagle XLT
Receiver. The TX and RX combine to create a long range radio
frequency system that operates hazardous or hard-to-reach electrical
apparatus from safe, convenient locations of up to 2500 feet away (Up
to 4 mile range with optional antennas). This unit has 7 network
frequencies and 16 digital addresses to allow multiple systems to
operate simultaneously in the same area without interference.
APPROVALS
United States (FCC)
Canada (IC)
INSTALLATION
1.
Mount the A
-E
XLT TRANSMITTER in a convenient location
IR
AGLE
where the operator will have easy access to the stop button.
2.
Install Ch. 2-4 wiring to contact input terminal strip if desired.
3.
Install the 2 AA Lithium batteries that were provided.
4.
Install antenna onto connector located on the right side on the
enclosure.
TERMINAL STRIP WIRING
Wire as shown based on number of contact inputs
1
2
3
4
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
XLT
MCQ-XB900HP
1846A-XB900HP
5
6
7
8
9
PRODUCT INFORMATION
Dimensions (with mounting plate) 6.3" L x 4.8" W x 4.3" H
CONTROLS & INDICATORS
10
TX LED
Dry Contact Inputs
SEL2
SEL1
BULLETIN
Illuminates green when power is applied.
Changes to red while any contact input is
closed and unit is transmitting. When this
LED blinks briefly following a transmission,
the battery needs to be replaced.
Transmits individual RF codes to the receiver
Dip switch bank for digital address selection
Dip switch bank for frequency selection