Table of Contents
Advertisement
40
Finalizing the Installation
Log Set Installation
Installation Warnings
NOTE: If using propane (LP), convert the appliance before installing the log set. If using firebacks,
install them prior to installing the log set.
The logs are fragile, especially after being exposed to heat.
Make sure the gas control valve is OFF and the heater is cool prior to conducting service.
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
The burner must be correctly positioned before installing the log set. Make sure the burner is fully
seated and the pilot is properly aligned. See owner's manual for details on burner removal.
Log Set Overview – Classic Oak 94500626
When installed, the ten (10) logs should appear as shown below.
Left Log
250-04918
Center Left Twig
250-04922
Left Twig
250-04921
© Travis Industries
Center Log
250-04924
Front Left Log
250-04916
5/3/2021 - 1554
(for qualified installers only)
Rear Log
250-04915
Center Twig
250-04923
564 GSR2 35K CF (AUST)
Right Twig
250-04920
Right Log
250-04919
Front Ember Chunk
250-04917
Advertisement
Table of Contents
