TANDBERG MPS 200 Administrator's Manual page 90

MPS 200/800
Contents Introduction
9@8&F#!1D&:#*;2<1!'(#*
PRI Board Configuration, Slot 1–n
The Network Type must correspond with configurations set
in the PRI Board Configuration .
Switch Type -
Select between the following PRI protocols:
!"
National ISDN
!"
AT&T Custom ISDN
!"
ETSI (Euro ISDN)
!"
Japan/Taiwan ISDN
NOTE! All PRI lines on the same E1/T1 Interface Card must
use the same PRI Protocol.
Trunk Groups
On:
When Trunk Groups is enabled, all of the PRI lines on the
same E1/T1 Interface Card will use the same number range
as specified for PRI 1, i.e. you will only need to specify the
number range start and stop for port 1 and leave the fields for
the other ports empty. (Default: On)
It is however necessary to set each individual port to On/Off
in the Interface Configuration section below in this menu. See
the next page.
Off:
When set to Off, the Trunk Groups is disabled.
Initial Restart
On: When set to On, the PRI interfaces will be reinitialized
after boot (Default: On).
Off: When set to Off, the PRI interfaces will not be reinitialized
after boot.
Alert
On:
If set to On, the system will respond with an alert mes-
sage to all incoming setup messages.
Off:
If set to Off, the system will respond with an alert mes-
sage only to the incoming setup message related to the initial
channel (Default: Off).
D14033.10—APRIL 2009
Getting started Using the MPS
, cont...
System status System configuration Gateway configuration !"#$%&'()*+ ',-./$0)*
Save
- Press the Save button to save changes.
Administrator Guide
MCU configuration Appendices Contact us
89