TANDBERG MPS 200 Administrator's Manual page 137

MPS 200/800
Contents Introduction
MCU Conference Template,
Video settings
Conference Template Configuration
The Conference Templates are found in the MCU Configuration tab.
The predefined settings will be used as default settings when creating
new conferences based on this specific template. TANDBERG MPS
enables the setup of 10 different conference templates.
The conference template contains the same settings as de-
scribed in the Overview > MCU > Create Conference section.
Dual Video Stream
TF
The MCU supports DuoVideo , H.239 and BFCP.
On: Set to On to enable Dual Video Stream for this conference. Both
TF
DuoVideo , H.239 are supported in the same conference.
Off: When set to Off, Dual Video Stream will not be supported in this
conference.
Conference Selfview
On: Set to On to enable Conference Selfview. The user will see himself
in the picture when more than one participant is in the conference.
Off: Set to Off to disable Conference Selfview.
Telephone Indication
On: Set to On to enable a Telephone Indicator to be displayed when
there are telephone (audio only) participants connected to the confer-
ence. When the telephone participant is speaking the indicator will be
outlined.
Off:
Set to Off to disable the Telephone Indicator to be displayed.
Speaker Indication
On: Set to On to enable a Speaker Indicator (a coloured line) to be
displayed around the sub-picture that will indicate who is the currently
speaking participant.
Off:
Set to Off to disable the coloured line to be displayed.
D14033.10—APRIL 2009
Getting started Using the MPS
cont...
System status System configuration Gateway configuration
Lecture Mode
On: Set to On to enable the Lecturer to be displayed in full
screen to the other participants.
!"
The Lecturer is the participant which is assigned floor.
!"
The Lecturer will see a scan of all the participants in a full
screen view or one of the supported sub-picture views.
Off: Set to Off to disable the Lecturer, the participant which is
assigned floor, to be view in full screen.
Administrator Guide
MCU configuration 345'()*+ ',-./$0)* Appendices
Save
Press to activate the new settings
Contact us
136