TANDBERG MPS 200 Administrator's Manual page 88

MPS 200/800
Contents Introduction
9@8&F#!1D&:#*;2<1!'(#*
PRI Board Configuration, Slot 1–n
The Network Type must correspond with configurations set
in the PRI Board Configuration .
Send Complete
On:
The TANDBERG MPS will send the ISDN message informa-
tion element <Sending Complete> in the outgoing call
Setup message. This is only required in a few countries.
Off:
The TANDBERG MPS will not send <Sending Com-
plete> (Default: Off).
Send Number
On:
The TANDBERG MPS will send its own number to the far
end. This is only useful when each conference have specified
a Dial In number (Default: On).
Off:
The TANDBERG MPS will not send its own number to
the far end. Please note that the network may still send your
number to the far end.
Parallel Dial
On:
Channels will be dialed and connected in parallel when
setting up a BONDING call (Default: On).
Off:
Channels will be dialed sequentially, which may increase
setup time.
HLC
On:
Enables sending of HLC (High Level Compatibility) infor-
mation element in setup message (video calls only).
Off:
Disables sending of HLC information element in setup
message (video calls only), (Default: Off).
D14033.10—APRIL 2009
Getting started Using the MPS System status System configuration Gateway configuration !"#$%&'()*+ ',-./$0)*
Save
- Press the Save button to save changes.
Administrator Guide
MCU configuration Appendices Contact us
87